Frameless shower doors are a great way to make an old bathroom feel new again. Installing them is not as hard as you think, but it can be tricky. This guide will show you how to install a glass shower door in 9 simple steps. You will have a new, beautiful shower door installed in no time at all.
Steps To Install A Frameless Shower Door
Follow these steps to install a shower door with confidence. Your glass shower door will look great and function perfectly for years to come!
Measure Your Door:
Before you get started, be sure to measure your door. Measure the width of your existing shower door, then measure the length of your new frameless shower door. You want to make sure that you have enough space in between them to slide in a piece of glass.
Select Supplies:
Once you know the dimensions of your shower and have determined whether or not it is structurally sound, you can start to select the supplies that you need for installation. Depending on what type of shower door hardware you want to install, you will need different supplies. On the other hand, if you are installing a new shower door or replacing the entire track system, then you may also need tools like drill bits and mounting brackets. Now that you’ve measured the bottom track and confirmed it’s the proper width, it’s time to cut it to size.
Install The Bottom Track:
Once you’ve cut the bottom track to size, it’s time to install it. Make sure the bottom of each joint is flush with the floor so water doesn’t leak in behind. You can use a rubber mallet or hammer if necessary. Once you’ve installed all four pieces of the bottom track, make sure they’re level using a carpenter’s level. Once you’ve installed the bottom track, you can install the top track.
Cut The Top Track:
Before cutting your top track to size, you’ll need to measure and mark where each joint will be. It is because you want the joints between each piece of metal to line up perfectly with one another so they form a smooth line when looking down at them from above.
Cut The Side Tracks:
Cut each side track to size and then attach them to the ends of your bottom and top tracks using screws. Make sure you use a screwdriver that fits the screws perfectly so they don’t get stripped when tightening them down. You can also drill pilot holes into the metal so they’re easier to drive.
Attach Wall Assemblies To Tracks:
Before you can install your frameless shower door, you’ll need to attach the wall assemblies to the track. It is a fairly easy process that can be done in just a few steps. First, take one of your wall assemblies and measure from the bottom of it to where you want the top edge of your frameless shower door to be. Use this measurement as a guide when screwing each wall assembly into place using screws or anchors.
Place Glass Panel Into Door Frame:
Once you have attached all three parts of the shower door, you can then place the glass panel into the frame. Use a silicone sealant around each edge to make sure that it is air-tight and water-tight. It will keep moisture from getting in between the frame and glass which could cause damage to either one or both.
Secure And Adjust Sliding Door:
Once you have the glass panel installed, then you can secure and adjust your sliding shower door. You will want to make sure that all of the frames are level and flush with each other so that it slides easily without getting stuck. If you have any gaps where there is no sealant on the frame, use some caulk to fill them in so that water does not leak out when it rains or when someone showers.
Conclusion
Installing a frameless shower door can be a little tricky, but if you follow the above steps carefully and take your time, then you will have no problem completing this project on your own. However, if you are still having trouble, then you may want to hire a professional to do this for you. A professional will be able to install the door quickly and correctly so that it is watertight and ready to use in no time at all.
